for All Honeywell Systems

Training Systems for all HVAC Systems and a whole lot more!

Helpful Links!

CarRentals, LLC

Corporate Info Tech Services
XBS Systems  >  CXBS1003

CXBS1003           XBS Excel 5000 Remote Hardware/Software Installation


Class Type            Installation


System                   XBS Central


Duration                3.0 days


Class Audience    Operators of  down-line XBS processors and/or maintenance personnel for the XBS 

                                Controllers in XBS Central or XBS-i Central HVAC Systems


Offered At             Customer site or St Paul


# of Students        Minimum 5,  Maximum 8 


Cost                        $1095 per person at site, $795 per person St Paul


Pre-requisites      None


Brief                      The basic objective of the course is to prepare the student for the physical installation and wiring of all XBS system remote modules, enhancements and extensions.  The course starts with an extensive block diagram of an XBS System and its extensions and enhancements. Students are encouraged to relate the discussion to their own systems if any, and bring up any points that they may need clarification on.  This module of the class is basically a thorough discussion of the entire system and is invaluable to make the students at home with their systems.


The course then goes into a full discussion of system documentation interpretation as prepared by Honeywell or other engineers.  This knowledge is essential for proper installation of the many XBS system modules.  This is followed by an extensive discussion and illustration of system wiring and wiring termination for all the major XBS system remote modules.


The course also discusses system bus wiring and wiring termination.  In addition wiring for all system operator units, printers, remote units, and all service computers is discussed.  Unpacking, dismantling and putting together of critical modules is covered.   


Objectives             Upon completion of the course the student will be able to:


·         Describe the hardware components of the XBS Central System

·         Exhibit an understanding of the function and purpose of each Hardware Module in the XBS system

·         Demonstrate a working knowledge/logical understanding of the XBS Engineering Process

·         Unpack and physically mount all Excel Hardware

·         Perform all wiring terminations for all Excel Hardware Modules

·         Exhibit knowledge of all wiring terminations from the maintenance point of view

·         Perform all controller Load/Dump and software/firmware install functions

·         Interpret and use site documentation created by Honeywell or other engineers



·         System Hardware/Software Overview

·         Unpacking/mounting of all Excel Controller Modules and other components

·         System Wiring Terminations    

·         System Documentation Interpretation

Powered by PDshop & Asp.Net
ASP.NET Shopping Cart Software